Porcelain Tile / September 7, 2018 / Brousseau
How to lean in... To lean in simply start the drill at an angle as soon as the drill bit has started to cut the tile slowly bring the drill into a vertical position. Ensure that sufficient pressure is being applied (tile dust should be evident in cooling water) and rotate slowly until you have cut the perfect hole. As you finish the hole you will notice that the tone of the drill will change. Using sticky drive pads. If you use a sticky drive pad it is unnecessary to use the leaning in method.
Glazed porcelain tiles are ideal for the perfect flooring in your home. There are many differences between porcelain tiles and ceramic tiles for use on your floors or walls. Ceramic tiles are made from red or white clay and are fired then finished with a glaze that helps the pattern and colours to be sustained. These are normally easy to cut due to softer materials and have a PEI 0-3 rating. Porcelain tiles are made by dust pressed methods from porcelain clay that creates a fine grain and smooth face.
In choosing your tiles do not get confused with the terms non-porcelain and ceramic tiles because although technically porcelain is a kind of ceramic ware the term ceramic tile is usually referred to as non-porcelain. These tiles are hard and non-porous and absorb very minimal water as compared to ceramic tiles which are softer and have high water absorption. Porcelain tiles are highly durable because they can resist abrasions unlike ceramic tiles that are prone to chipping and scratches.