Porcelain Tile / September 7, 2018 / Brousseau
Simply start the drill in a vertical position and the sticky pad will ensure that the drill does not slip. Once you have finished drilling the tile simply peel off the sticky drive pad. Because the majority of small diameter holes will be cut into tiles already fixed to the wall it will be necessary to drill a fixing hole behind the tile. Replace the diamond core with the appropriately sized masonry drill bit and set the drill to hammer mode. Use a slow speed for drilling into hard materials to ensure that the tip doesnt overheat. Ensure that the drill bit is frequently withdrawn in order to stop a build up of dust.
Cheap porcelain tiles can be difficult to properly install. Cheap tiles may look nice on the surface but they may not be able to be cut cleanly with a tile saw and may chip on the edges. Also if the tiles are porous then it will be difficult to clean up the excess grout. Grout haze can become embedded in the tiles and make them look vastly different after they are installed compared to what they looked like before they were installed. Cheap tiles can have quality control issues. Many times people choose their sample tile and then order them.
Drilling holes into porcelain tile should take seconds not minutes. If it is taking you minutes it is likely that you are not applying enough pressure or that you are using an incorrect setting on the power tool. Best Tools for the Job. In order to drill perfect holes in porcelain tile it is extremely important to use premium quality drill bits. Armeg have been producing innovative high quality drilling solutions for over 30 years and Armegs PTC (Porcelain Tile Cutter) range is at the forefront of tile drilling technology.