Porcelain Tile / September 14, 2018 / Brousseau
Ensure that scrap tiles or another similar material is placed under the tile that is being drilled. This will help to halt the progress of the drill once it has finished drilling through the tile. Before drilling tile ensure that you are wearing the correct safety equipment including safety glasses or goggles. Ensure that you are using a residual current device (RCD) to help prevent electric shock. Drilling Small Diameter Holes (10mm or Smaller) with Diamond Cores. Mark the center of the hole to be drilled into the tile by using a marker or a sticky drive pad.
To choose the right tiles that would best fit your needs it is important not to get lost with such terms as ceramic tiles non-porcelain or ceramic porcelain. All of these terms refer to a kind of ceramic ware however they differ in characteristics application and production method. Ceramic tiles are usually referred to as non-porcelain tiles and they are easier to cut and have higher water absorption as compared to porcelain. Unlike porcelain tiles ceramic tiles cannot absorb heavy impact or heavy foot traffic as they have a tendency to chip and abrade.
Drilling Small Diameter Holes (10mm or Smaller) with Carbide Bits. Firstly mark where the hole will be drilled on the tile using a marker. Attach a carbide drill bit to your drill. Ensure that there is a constant supply of cold water that is being directly aimed at the selected drill bit i.e. by using water cooling equipment. Note regarding water cooling. It is important to ensure that there is a constant supply of cold water in order to keep the drill bit cool and to help remove any debris that may have built up whilst drilling the tile.