Porcelain Tile / September 14, 2018 / Brousseau
It is not advisable to try and cool the drill bit by using an aspirator or drilling through a wet sponge these methods will not keep the drill bit cool enough and the drill bit will burn out. Set the electric drill to between 700 and 900 rpm. Make sure that the drill is in normal mode. Push the carbide drill bit gently into where you have marked the tile until you hear a cracking sound. Start drilling from a vertical position with sufficient pressure and dont stop until you hear a change in the tone of the drill. As soon as you hear the change in the tone begin to ease off.
The Porcelain Enamel Institute (PEI) rating system is also a good reference when buying your porcelain tiles. In the rating system the tiles are measured according to their application. The range starts from PEI Class 1 up to PEI Class 5. When looking for the perfect porcelain tile designs for your home you can choose from a variety of designs that are glazed unglazed or through-bodied in color composition. Whatever your preference porcelain tiles are guaranteed to make your home cozy and beautiful.
Drilling Small Diameter Holes (10mm or Smaller) with Carbide Bits. Firstly mark where the hole will be drilled on the tile using a marker. Attach a carbide drill bit to your drill. Ensure that there is a constant supply of cold water that is being directly aimed at the selected drill bit i.e. by using water cooling equipment. Note regarding water cooling. It is important to ensure that there is a constant supply of cold water in order to keep the drill bit cool and to help remove any debris that may have built up whilst drilling the tile.