Porcelain Tile / September 14, 2018 / Brousseau
Ensure that scrap tiles or another similar material is placed under the tile that is being drilled. This will help to halt the progress of the drill once it has finished drilling through the tile. Before drilling tile ensure that you are wearing the correct safety equipment including safety glasses or goggles. Ensure that you are using a residual current device (RCD) to help prevent electric shock. Drilling Small Diameter Holes (10mm or Smaller) with Diamond Cores. Mark the center of the hole to be drilled into the tile by using a marker or a sticky drive pad.
How to lean in... To lean in simply start the drill at an angle as soon as the drill bit has started to cut the tile slowly bring the drill into a vertical position. Ensure that sufficient pressure is being applied (tile dust should be evident in cooling water) and rotate slowly until you have cut the perfect hole. As you finish the hole you will notice that the tone of the drill will change. Using sticky drive pads. If you use a sticky drive pad it is unnecessary to use the leaning in method.
In choosing your tiles do not get confused with the terms non-porcelain and ceramic tiles because although technically porcelain is a kind of ceramic ware the term ceramic tile is usually referred to as non-porcelain. These tiles are hard and non-porous and absorb very minimal water as compared to ceramic tiles which are softer and have high water absorption. Porcelain tiles are highly durable because they can resist abrasions unlike ceramic tiles that are prone to chipping and scratches.