Porcelain Tile / September 14, 2018 / Brousseau
The Armeg PTC Carbide drill bit range comprises of excellent porcelain tile drill bits that are capable of cutting 15-25 holes in grade 5 porcelain or 50+ in lesser grades of porcelain. These carbide drill bits boast non-slip start-up thanks to diamond-ground tip geometry. The Armeg PTC Soft Tile drill bit range is ideal for drilling softer tiles such as ceramics and travertine. They feature point-ground tips to help reduce slippage and wander. Armeg Tile Drilling Accessories for use with Armeg PTC drill bits include: water feed pump kit water feed adapters water feed clamp & drive/piloting guides to ensure non-slip start-up with small diameter diamond cores.
How to lean in... To lean in simply start the drill at an angle as soon as the drill bit has started to cut the tile slowly bring the drill into a vertical position. Ensure that sufficient pressure is being applied (tile dust should be evident in cooling water) and rotate slowly until you have cut the perfect hole. As you finish the hole you will notice that the tone of the drill will change. Using sticky drive pads. If you use a sticky drive pad it is unnecessary to use the leaning in method.
Porcelain tiles may be classified into natural glazed and polished tiles. The natural porcelain tile normally does not undergo any further finish after it is exposed to high temperature. This type of tile may be referred to as unglazed or through body tile where the colour goes all the way through. The glazed tile is coated with liquid glass that allows the manufacturer to put in a variety of designs and play around with colours. It comes out glossy and is one of the easiest to maintain. They are highly recommended as walls or accents in bathrooms and kitchen.