Porcelain Tile / September 3, 2018 / Brousseau.
To get more acquainted with the product porcelain is defined in the Meriam-Webster Dictionary as a fine grained translucent ceramic ware. There are different kinds of ceramic materials but porcelain comes from the more common type of material called whiteware. Porcelain was first discovered in China and it is believed to have been brought to Europe by the great merchant and explorer Marco Polo. The term porcelain was derived from the translucent shell porcellana because of its similarity to the cowrie shell.
Now that the pilot hole has been cut it is possible to drill the main (large) hole. Attach the appropriate diamond core and ensure that there is a constant supply of cold water (see water cooling information in the previous sections of this article). Diamond cores that are larger than 13mm will require an adapter with pilot pin that locates into the pilot hole that has been cut previously to ensure the perfect hole will be made. Starting the drill vertically begin to drill in a circular motion with sufficient pressure until the tone of the drill changes.
The Kaska glazed porcelain offers a Tiger Cotto and Noce series. These tiles are comparatively priced and offer a full colour body porcelain tile. These tiles are made in Turkey and have standard edges and a PEI 4 rating. These tiles are ideal for floors or walls in any home with any amount of traffic. The glaze on the tiles helps to protect and lengthen the life of the tiles so they can be used in the kitchen near the doors or even on the walls to beautify your home.
Simply start the drill in a vertical position and the sticky pad will ensure that the drill does not slip. Once you have finished drilling the tile simply peel off the sticky drive pad. Because the majority of small diameter holes will be cut into tiles already fixed to the wall it will be necessary to drill a fixing hole behind the tile. Replace the diamond core with the appropriately sized masonry drill bit and set the drill to hammer mode. Use a slow speed for drilling into hard materials to ensure that the tip doesnt overheat. Ensure that the drill bit is frequently withdrawn in order to stop a build up of dust.