Porcelain Tile / September 5, 2018 / Brousseau.
The Kaska glazed porcelain offers a Tiger Cotto and Noce series. These tiles are comparatively priced and offer a full colour body porcelain tile. These tiles are made in Turkey and have standard edges and a PEI 4 rating. These tiles are ideal for floors or walls in any home with any amount of traffic. The glaze on the tiles helps to protect and lengthen the life of the tiles so they can be used in the kitchen near the doors or even on the walls to beautify your home.
Identifying the Size of Hole to be Drilled. The first step is to correctly identify the size of hole to be drilled. This is very important as the diameter of the hole to be cut dictates the method that you will use to drill into the tile. The majority of holes that are 10mm and under in diameter will be drilled with the tile already fixed to the wall. Conversely the majority of holes over 10mm in diameter will be drilled into the tile before the tile has been fixed. When drilling holes that are 13mm or larger in diameter make sure that the tile to be drilled is placed in a tray that will collect the waste water that is produced.
Glazed porcelain can be found through many online retailers for varying costs. Here are a few different types of glazed porcelain that can be used in any area of the home. The Wood Grain Collection made by Takla offers your floors the hard wood appearance with the protection of glazed porcelain. These tiles have a water absorption rate of less than 0.05% and are first grade quality porcelain. The thickness of the average tile of this type is 3/8 inch and the finish is matter and slightly embossed to have the appearance of wood grain. The PEI rating for these tiles is 4 and they are considered a green building material.
These methods will not keep the drill bits cool enough and will drastically shorten the life of the drill bit. Ensure that the drill is in normal mode and set the drill to between 1000 and 1500 rpm. If you have marked the tile with a marker it is best to drill into the tile using a method called leaning in. Leaning in ensures that the drill will not slip and wander off center as you begin to drill into the tile.