Porcelain Tile / August 29, 2018 / Brousseau
Ensure that scrap tiles or another similar material is placed under the tile that is being drilled. This will help to halt the progress of the drill once it has finished drilling through the tile. Before drilling tile ensure that you are wearing the correct safety equipment including safety glasses or goggles. Ensure that you are using a residual current device (RCD) to help prevent electric shock. Drilling Small Diameter Holes (10mm or Smaller) with Diamond Cores. Mark the center of the hole to be drilled into the tile by using a marker or a sticky drive pad.
How to lean in... To lean in simply start the drill at an angle as soon as the drill bit has started to cut the tile slowly bring the drill into a vertical position. Ensure that sufficient pressure is being applied (tile dust should be evident in cooling water) and rotate slowly until you have cut the perfect hole. As you finish the hole you will notice that the tone of the drill will change. Using sticky drive pads. If you use a sticky drive pad it is unnecessary to use the leaning in method.
These tiles offer more water resistance and frost resistance than ceramic tiles. Glazed porcelain tiles offer a surface that is resistant to wear and tear and a harder surface that is great for high traffic areas such as the kitchen or tea room. Full porcelain floor tiles have a colour and pattern that follows through to the base of the tile so the patterns are never worn away like ceramic tiles. Glazed porcelain tiles are coated with liquid glass and then baked so that the protection is impervious to wear and tear as well as stains.