Porcelain Tile / September 12, 2018 / Brousseau.
Attach the appropriate diamond core bit to the electric drill and ensure that there is a constant supply of cold water that is being directly aimed at the diamond core i.e. by using water cooling equipment. Note regarding water cooling. It is important to ensure that there is a constant supply of cold water directed at the drill bit in order to keep the diamond core cool and to help remove any debris that may have built up whilst drilling the tile. It is not advisable to try and cool the diamond drill bit by using a hand held aspirator or drilling through a wet sponge.
Glazed porcelain can be found through many online retailers for varying costs. Here are a few different types of glazed porcelain that can be used in any area of the home. The Wood Grain Collection made by Takla offers your floors the hard wood appearance with the protection of glazed porcelain. These tiles have a water absorption rate of less than 0.05% and are first grade quality porcelain. The thickness of the average tile of this type is 3/8 inch and the finish is matter and slightly embossed to have the appearance of wood grain. The PEI rating for these tiles is 4 and they are considered a green building material.
The Kaska glazed porcelain offers a Tiger Cotto and Noce series. These tiles are comparatively priced and offer a full colour body porcelain tile. These tiles are made in Turkey and have standard edges and a PEI 4 rating. These tiles are ideal for floors or walls in any home with any amount of traffic. The glaze on the tiles helps to protect and lengthen the life of the tiles so they can be used in the kitchen near the doors or even on the walls to beautify your home.
Now that the pilot hole has been cut it is possible to drill the main (large) hole. Attach the appropriate diamond core and ensure that there is a constant supply of cold water (see water cooling information in the previous sections of this article). Diamond cores that are larger than 13mm will require an adapter with pilot pin that locates into the pilot hole that has been cut previously to ensure the perfect hole will be made. Starting the drill vertically begin to drill in a circular motion with sufficient pressure until the tone of the drill changes.