Porcelain Tile / September 14, 2018 / Brousseau
The Armeg PTC Diamond drill bit range boasts diamond core drill bits that are capable of cutting hundreds of holes in all grades of porcelain. They feature thin wall continuous diamond crowns for and fast and efficient cutting and an extended life. These diamond cores are not to be confused with short-life diamond grit alternatives. Not only do these diamond drill bits cut porcelain they also cut materials such as marble granite travertine slate quarry tiles ceramic tiles natural stone and limestone.
How to lean in... To lean in simply start the drill at an angle as soon as the drill bit has started to cut the tile slowly bring the drill into a vertical position. Ensure that sufficient pressure is being applied (tile dust should be evident in cooling water) and rotate slowly until you have cut the perfect hole. As you finish the hole you will notice that the tone of the drill will change. Using sticky drive pads. If you use a sticky drive pad it is unnecessary to use the leaning in method.
The hardness of porcelain tiles is an advantage for more reasons than appearance. This quality makes these tiles far more scratch resistant than ceramic tiles. When tiles get scratched up you have to go to a lot of expense and trouble to get them polished out and sometimes even that isnt possible. Porcelain tiles are also more resistant to chipping. This hardy nature also makes them less slippery than ceramic tiles which makes them a better choice for safety reasons as well.