Porcelain Tile / September 13, 2018 / Brousseau
To choose the right tiles that would best fit your needs it is important not to get lost with such terms as ceramic tiles non-porcelain or ceramic porcelain. All of these terms refer to a kind of ceramic ware however they differ in characteristics application and production method. Ceramic tiles are usually referred to as non-porcelain tiles and they are easier to cut and have higher water absorption as compared to porcelain. Unlike porcelain tiles ceramic tiles cannot absorb heavy impact or heavy foot traffic as they have a tendency to chip and abrade.
Identifying the Size of Hole to be Drilled. The first step is to correctly identify the size of hole to be drilled. This is very important as the diameter of the hole to be cut dictates the method that you will use to drill into the tile. The majority of holes that are 10mm and under in diameter will be drilled with the tile already fixed to the wall. Conversely the majority of holes over 10mm in diameter will be drilled into the tile before the tile has been fixed. When drilling holes that are 13mm or larger in diameter make sure that the tile to be drilled is placed in a tray that will collect the waste water that is produced.
How to lean in... To lean in simply start the drill at an angle as soon as the drill bit has started to cut the tile slowly bring the drill into a vertical position. Ensure that sufficient pressure is being applied (tile dust should be evident in cooling water) and rotate slowly until you have cut the perfect hole. As you finish the hole you will notice that the tone of the drill will change. Using sticky drive pads. If you use a sticky drive pad it is unnecessary to use the leaning in method.