Porcelain Tile / August 29, 2018 / Brousseau
How to lean in... To lean in simply start the drill at an angle as soon as the drill bit has started to cut the tile slowly bring the drill into a vertical position. Ensure that sufficient pressure is being applied (tile dust should be evident in cooling water) and rotate slowly until you have cut the perfect hole. As you finish the hole you will notice that the tone of the drill will change. Using sticky drive pads. If you use a sticky drive pad it is unnecessary to use the leaning in method.
Recommended Equipment for Drilling Porcelain Tile. High quality diamond core drill bits. Carbide pilot drill bit - only required if youre drilling large diameter holes (13mm or larger) and dont have a suitable-sized (8mm) diamond drill bit. Masonry drill bits - included with quality tile drill bits. Water cooling equipment. Electric drill Clear safety glasses / goggles.
Because the majority of small diameter holes will be cut into tiles already fixed to the wall it will be necessary to drill a fixing hole behind the tile. Replace the carbide drill bit with the appropriately sized masonry drill bit and set the drill to hammer mode. Use a slow speed for drilling into hard materials to ensure that the tip doesnt overheat. Ensure that the drill bit is frequently withdrawn in order to stop a build up of dust.