Porcelain Tile / September 9, 2018 / Brousseau
The hardness of porcelain tiles is an advantage for more reasons than appearance. This quality makes these tiles far more scratch resistant than ceramic tiles. When tiles get scratched up you have to go to a lot of expense and trouble to get them polished out and sometimes even that isnt possible. Porcelain tiles are also more resistant to chipping. This hardy nature also makes them less slippery than ceramic tiles which makes them a better choice for safety reasons as well.
Identifying the Size of Hole to be Drilled. The first step is to correctly identify the size of hole to be drilled. This is very important as the diameter of the hole to be cut dictates the method that you will use to drill into the tile. The majority of holes that are 10mm and under in diameter will be drilled with the tile already fixed to the wall. Conversely the majority of holes over 10mm in diameter will be drilled into the tile before the tile has been fixed. When drilling holes that are 13mm or larger in diameter make sure that the tile to be drilled is placed in a tray that will collect the waste water that is produced.
Simply start the drill in a vertical position and the sticky pad will ensure that the drill does not slip. Once you have finished drilling the tile simply peel off the sticky drive pad. Because the majority of small diameter holes will be cut into tiles already fixed to the wall it will be necessary to drill a fixing hole behind the tile. Replace the diamond core with the appropriately sized masonry drill bit and set the drill to hammer mode. Use a slow speed for drilling into hard materials to ensure that the tip doesnt overheat. Ensure that the drill bit is frequently withdrawn in order to stop a build up of dust.