Porcelain Tile / September 13, 2018 / Brousseau
How to lean in... To lean in simply start the drill at an angle as soon as the drill bit has started to cut the tile slowly bring the drill into a vertical position. Ensure that sufficient pressure is being applied (tile dust should be evident in cooling water) and rotate slowly until you have cut the perfect hole. As you finish the hole you will notice that the tone of the drill will change. Using sticky drive pads. If you use a sticky drive pad it is unnecessary to use the leaning in method.
Identifying the Size of Hole to be Drilled. The first step is to correctly identify the size of hole to be drilled. This is very important as the diameter of the hole to be cut dictates the method that you will use to drill into the tile. The majority of holes that are 10mm and under in diameter will be drilled with the tile already fixed to the wall. Conversely the majority of holes over 10mm in diameter will be drilled into the tile before the tile has been fixed. When drilling holes that are 13mm or larger in diameter make sure that the tile to be drilled is placed in a tray that will collect the waste water that is produced.
Some of the more common issues that cheap porcelain tiles can have include: Cheap porcelain tiles can actually be extremely porous and difficult to clean. They will absorb all types of dirt spills and contaminates. These types of porous tiles will start to show dirty spots especially in heavy use areas and in the center of the floor where people walk. Soon your floor will look ugly and these types of deeply embedded stains are extremely difficult to clean. Often times it can help to seal these porous tiles but this can be costly and time consuming especially for a product that you thought was dense and would be easy to clean and maintain.