Porcelain Tile / September 6, 2018 / Brousseau
How to lean in... To lean in simply start the drill at an angle as soon as the drill bit has started to cut the tile slowly bring the drill into a vertical position. Ensure that sufficient pressure is being applied (tile dust should be evident in cooling water) and rotate slowly until you have cut the perfect hole. As you finish the hole you will notice that the tone of the drill will change. Using sticky drive pads. If you use a sticky drive pad it is unnecessary to use the leaning in method.
Recommended Equipment for Drilling Porcelain Tile. High quality diamond core drill bits. Carbide pilot drill bit - only required if youre drilling large diameter holes (13mm or larger) and dont have a suitable-sized (8mm) diamond drill bit. Masonry drill bits - included with quality tile drill bits. Water cooling equipment. Electric drill Clear safety glasses / goggles.
The term porcelain was coined from the Italian word porcellana because of its translucent characteristic similar to the cowrie shell. Porcelain was first developed in China and was exported to Europe between the 17th and 18th century. Beautiful jars and other delicate ornaments were made from porcelain but the discovery of its base material from soft paste to hard past has made porcelain an important industrial commodity. Porcelain is resistant to high temperatures resistant to abrasions and is also non-porous which allows very minimal water absorption. Today porcelain is an important material for insulation and is popularly used for dental prosthesis and veneers. That is why porcelain tiles are excellent choices for residential and commercial finishing.