Porcelain Tile / September 9, 2018 / Brousseau
Drilling Small Diameter Holes (10mm or Smaller) with Carbide Bits. Firstly mark where the hole will be drilled on the tile using a marker. Attach a carbide drill bit to your drill. Ensure that there is a constant supply of cold water that is being directly aimed at the selected drill bit i.e. by using water cooling equipment. Note regarding water cooling. It is important to ensure that there is a constant supply of cold water in order to keep the drill bit cool and to help remove any debris that may have built up whilst drilling the tile.
The Kaska glazed porcelain offers a Tiger Cotto and Noce series. These tiles are comparatively priced and offer a full colour body porcelain tile. These tiles are made in Turkey and have standard edges and a PEI 4 rating. These tiles are ideal for floors or walls in any home with any amount of traffic. The glaze on the tiles helps to protect and lengthen the life of the tiles so they can be used in the kitchen near the doors or even on the walls to beautify your home.
Simply start the drill in a vertical position and the sticky pad will ensure that the drill does not slip. Once you have finished drilling the tile simply peel off the sticky drive pad. Because the majority of small diameter holes will be cut into tiles already fixed to the wall it will be necessary to drill a fixing hole behind the tile. Replace the diamond core with the appropriately sized masonry drill bit and set the drill to hammer mode. Use a slow speed for drilling into hard materials to ensure that the tip doesnt overheat. Ensure that the drill bit is frequently withdrawn in order to stop a build up of dust.