Porcelain Tile / September 7, 2018 / Brousseau
It is not advisable to try and cool the drill bit by using an aspirator or drilling through a wet sponge these methods will not keep the drill bit cool enough and the drill bit will burn out. Set the electric drill to between 700 and 900 rpm. Make sure that the drill is in normal mode. Push the carbide drill bit gently into where you have marked the tile until you hear a cracking sound. Start drilling from a vertical position with sufficient pressure and dont stop until you hear a change in the tone of the drill. As soon as you hear the change in the tone begin to ease off.
There are many different types of tiles on the market today. Most people want the best possible type of tile floor they can afford and they also want it to look beautiful and last for many years. There are also cleaning and maintenance issues that must be considered when choosing tile flooring. Many people desire the natural beauty of stone and are willing to deal with the increased cleaning and maintenance issues that come with stone. Other people like the uniform look of ceramic and porcelain and they do not want to deal with some of the hassles involved with stone tile floors.
How to lean in... To lean in simply start the drill at an angle as soon as the drill bit has started to cut the tile slowly bring the drill into a vertical position. Ensure that sufficient pressure is being applied (tile dust should be evident in cooling water) and rotate slowly until you have cut the perfect hole. As you finish the hole you will notice that the tone of the drill will change. Using sticky drive pads. If you use a sticky drive pad it is unnecessary to use the leaning in method.