Porcelain Tile / August 29, 2018 / Brousseau
Porcelain tile and ceramic tile both start off the same being composed of more or less the same materials such as clay and quartz. After formation they are both fired to high temperatures. What spells out the difference between the ceramic white tile and porcelain tile is that the latter uses a more highly refined and purified clay making the porcelain tile denser than the other tile. This is an extremely important difference since being more dense means that porcelain tile absorbs far less moisture making it both durable and stain resistant.
How to lean in... To lean in simply start the drill at an angle as soon as the drill bit has started to cut the tile slowly bring the drill into a vertical position. Ensure that sufficient pressure is being applied (tile dust should be evident in cooling water) and rotate slowly until you have cut the perfect hole. As you finish the hole you will notice that the tone of the drill will change. Using sticky drive pads. If you use a sticky drive pad it is unnecessary to use the leaning in method.
The Armeg PTC Carbide drill bit range comprises of excellent porcelain tile drill bits that are capable of cutting 15-25 holes in grade 5 porcelain or 50+ in lesser grades of porcelain. These carbide drill bits boast non-slip start-up thanks to diamond-ground tip geometry. The Armeg PTC Soft Tile drill bit range is ideal for drilling softer tiles such as ceramics and travertine. They feature point-ground tips to help reduce slippage and wander. Armeg Tile Drilling Accessories for use with Armeg PTC drill bits include: water feed pump kit water feed adapters water feed clamp & drive/piloting guides to ensure non-slip start-up with small diameter diamond cores.