Porcelain Tile / September 12, 2018 / Brousseau.
Now that the pilot hole has been cut it is possible to drill the main (large) hole. Attach the appropriate diamond core and ensure that there is a constant supply of cold water (see water cooling information in the previous sections of this article). Diamond cores that are larger than 13mm will require an adapter with pilot pin that locates into the pilot hole that has been cut previously to ensure the perfect hole will be made. Starting the drill vertically begin to drill in a circular motion with sufficient pressure until the tone of the drill changes.
Porcelain tiles may be classified into natural glazed and polished tiles. The natural porcelain tile normally does not undergo any further finish after it is exposed to high temperature. This type of tile may be referred to as unglazed or through body tile where the colour goes all the way through. The glazed tile is coated with liquid glass that allows the manufacturer to put in a variety of designs and play around with colours. It comes out glossy and is one of the easiest to maintain. They are highly recommended as walls or accents in bathrooms and kitchen.
With porcelain being one of the most popular choices of tile material available and with the trend for porcelain tile set to continue tilers have had to adapt their working methods and tools to be able to cater for the demands of their clients. Until recently a large number of tile fixers have shied away from the installation and drilling of porcelain tiles due its perceived difficulty. However drilling holes in porcelain tile is not difficult! Using the correct methods and the best tools for the job it is possible to achieve perfect cuts in a matter of seconds.
Ensure that scrap tiles or another similar material is placed under the tile that is being drilled. This will help to halt the progress of the drill once it has finished drilling through the tile. Before drilling tile ensure that you are wearing the correct safety equipment including safety glasses or goggles. Ensure that you are using a residual current device (RCD) to help prevent electric shock. Drilling Small Diameter Holes (10mm or Smaller) with Diamond Cores. Mark the center of the hole to be drilled into the tile by using a marker or a sticky drive pad.