Porcelain Tile / August 28, 2018 / Brousseau.
When the shipment arrives they can look vastly different from the ones that were originally ordered. Often the colors and textures can look different from the sample. Other times there may be surface scratches or other imperfections that make them look ugly. Once the shipment arrives at your door it can be extremely difficult to return them and ship them back. Other times the quality control issues are not noticed until the tiles are installed and then the manufacturer will never accept returns on already installed tiles no mater what types of problems they have.
Attach the appropriate diamond core bit to the electric drill and ensure that there is a constant supply of cold water that is being directly aimed at the diamond core i.e. by using water cooling equipment. Note regarding water cooling. It is important to ensure that there is a constant supply of cold water directed at the drill bit in order to keep the diamond core cool and to help remove any debris that may have built up whilst drilling the tile. It is not advisable to try and cool the diamond drill bit by using a hand held aspirator or drilling through a wet sponge.
Now that the pilot hole has been cut it is possible to drill the main (large) hole. Attach the appropriate diamond core and ensure that there is a constant supply of cold water (see water cooling information in the previous sections of this article). Diamond cores that are larger than 13mm will require an adapter with pilot pin that locates into the pilot hole that has been cut previously to ensure the perfect hole will be made. Starting the drill vertically begin to drill in a circular motion with sufficient pressure until the tone of the drill changes.
It is not advisable to try and cool the drill bit by using an aspirator or drilling through a wet sponge these methods will not keep the drill bit cool enough and the drill bit will burn out. Set the electric drill to between 700 and 900 rpm. Make sure that the drill is in normal mode. Push the carbide drill bit gently into where you have marked the tile until you hear a cracking sound. Start drilling from a vertical position with sufficient pressure and dont stop until you hear a change in the tone of the drill. As soon as you hear the change in the tone begin to ease off.