Porcelain Tile / July 26, 2018 / Brousseau.
Attach the appropriate diamond core bit to the electric drill and ensure that there is a constant supply of cold water that is being directly aimed at the diamond core i.e. by using water cooling equipment. Note regarding water cooling. It is important to ensure that there is a constant supply of cold water directed at the drill bit in order to keep the diamond core cool and to help remove any debris that may have built up whilst drilling the tile. It is not advisable to try and cool the diamond drill bit by using a hand held aspirator or drilling through a wet sponge.
The Armeg PTC Diamond drill bit range boasts diamond core drill bits that are capable of cutting hundreds of holes in all grades of porcelain. They feature thin wall continuous diamond crowns for and fast and efficient cutting and an extended life. These diamond cores are not to be confused with short-life diamond grit alternatives. Not only do these diamond drill bits cut porcelain they also cut materials such as marble granite travertine slate quarry tiles ceramic tiles natural stone and limestone.
Drilling holes into porcelain tile should take seconds not minutes. If it is taking you minutes it is likely that you are not applying enough pressure or that you are using an incorrect setting on the power tool. Best Tools for the Job. In order to drill perfect holes in porcelain tile it is extremely important to use premium quality drill bits. Armeg have been producing innovative high quality drilling solutions for over 30 years and Armegs PTC (Porcelain Tile Cutter) range is at the forefront of tile drilling technology.
Ensure that scrap tiles or another similar material is placed under the tile that is being drilled. This will help to halt the progress of the drill once it has finished drilling through the tile. Before drilling tile ensure that you are wearing the correct safety equipment including safety glasses or goggles. Ensure that you are using a residual current device (RCD) to help prevent electric shock. Drilling Small Diameter Holes (10mm or Smaller) with Diamond Cores. Mark the center of the hole to be drilled into the tile by using a marker or a sticky drive pad.