Porcelain Tile / September 9, 2018 / Brousseau.
Application of tiles are rated according to the Porcelain Enamel Institute (PEI) rating system from PEI Class 1 up to PEI Class 5. If you are looking for the right tiles to be used for your walls or ceiling the PEI Class 1 is recommended because the tiles are not exposed to any impact. You can choose the PEI Classes 2 and 3 for your bathroom tiles and the PEI Classes 3 to 5 as kitchen and tabletops and as flooring in any part of your home or building according to the impact foot traffic or exposure of the area where you will install your porcelain tiles.
Drilling Large Diameter Holes (13mm or Larger). In order to cut holes that are 13mm or larger in diameter it is necessary to first drill a pilot hole. The pilot hole will act as a locater for a large diamond core and will help you to drill a perfect hole in porcelain tile. Attach an 8mm carbide drill bit or 8mm diamond bit to your drill. Follow the instructions given above for either Drilling Small Diameter Holes (10mm or Smaller) with Diamond Cores or Drilling Small Diameter Holes (10mm or Smaller) with Carbide Bits depending on whether you are using diamond cores or carbide drill bits. Leave out the final step in either case as you wont be drilling a fixing hole behind the tile.
Cheap porcelain tiles can be difficult to properly install. Cheap tiles may look nice on the surface but they may not be able to be cut cleanly with a tile saw and may chip on the edges. Also if the tiles are porous then it will be difficult to clean up the excess grout. Grout haze can become embedded in the tiles and make them look vastly different after they are installed compared to what they looked like before they were installed. Cheap tiles can have quality control issues. Many times people choose their sample tile and then order them.
With porcelain being one of the most popular choices of tile material available and with the trend for porcelain tile set to continue tilers have had to adapt their working methods and tools to be able to cater for the demands of their clients. Until recently a large number of tile fixers have shied away from the installation and drilling of porcelain tiles due its perceived difficulty. However drilling holes in porcelain tile is not difficult! Using the correct methods and the best tools for the job it is possible to achieve perfect cuts in a matter of seconds.