Porcelain Tile / September 3, 2018 / Brousseau.
The polished porcelain on the other hand goes through a more refined process and comes out looking almost like a granite finish or has a glossy effect without the glaze. In choosing the perfect ceramic porcelain tiles for your finishing you must know the colour combination or contrast in the areas where you will install the tiles and the kind of exposure the tiles may be subjected to. You may discuss these with your architect or interior designer or you may refer to our website and get in touch with us so we can assist you the best way we can.
These tiles offer more water resistance and frost resistance than ceramic tiles. Glazed porcelain tiles offer a surface that is resistant to wear and tear and a harder surface that is great for high traffic areas such as the kitchen or tea room. Full porcelain floor tiles have a colour and pattern that follows through to the base of the tile so the patterns are never worn away like ceramic tiles. Glazed porcelain tiles are coated with liquid glass and then baked so that the protection is impervious to wear and tear as well as stains.
Application of tiles are rated according to the Porcelain Enamel Institute (PEI) rating system from PEI Class 1 up to PEI Class 5. If you are looking for the right tiles to be used for your walls or ceiling the PEI Class 1 is recommended because the tiles are not exposed to any impact. You can choose the PEI Classes 2 and 3 for your bathroom tiles and the PEI Classes 3 to 5 as kitchen and tabletops and as flooring in any part of your home or building according to the impact foot traffic or exposure of the area where you will install your porcelain tiles.
Drilling Large Diameter Holes (13mm or Larger). In order to cut holes that are 13mm or larger in diameter it is necessary to first drill a pilot hole. The pilot hole will act as a locater for a large diamond core and will help you to drill a perfect hole in porcelain tile. Attach an 8mm carbide drill bit or 8mm diamond bit to your drill. Follow the instructions given above for either Drilling Small Diameter Holes (10mm or Smaller) with Diamond Cores or Drilling Small Diameter Holes (10mm or Smaller) with Carbide Bits depending on whether you are using diamond cores or carbide drill bits. Leave out the final step in either case as you wont be drilling a fixing hole behind the tile.