Porcelain Tile / September 14, 2018 / Brousseau
Drilling Small Diameter Holes (10mm or Smaller) with Carbide Bits. Firstly mark where the hole will be drilled on the tile using a marker. Attach a carbide drill bit to your drill. Ensure that there is a constant supply of cold water that is being directly aimed at the selected drill bit i.e. by using water cooling equipment. Note regarding water cooling. It is important to ensure that there is a constant supply of cold water in order to keep the drill bit cool and to help remove any debris that may have built up whilst drilling the tile.
The Takla Roma Travertino Collection has a marbleised appearance and can be found through many retailers for varying costs. These tiles have a water absorption rate of 0.04% and are first grade quality porcelain with a matte finish. There are a few different mosaics available in this line of tiles whose thickness is right at 3/8 inch. Armeg SDS Plus tile removing chisel also available in this range.
How to lean in... To lean in simply start the drill at an angle as soon as the drill bit has started to cut the tile slowly bring the drill into a vertical position. Ensure that sufficient pressure is being applied (tile dust should be evident in cooling water) and rotate slowly until you have cut the perfect hole. As you finish the hole you will notice that the tone of the drill will change. Using sticky drive pads. If you use a sticky drive pad it is unnecessary to use the leaning in method.