Porcelain Tile / September 14, 2018 / Brousseau
Drilling holes into porcelain tile should take seconds not minutes. If it is taking you minutes it is likely that you are not applying enough pressure or that you are using an incorrect setting on the power tool. Best Tools for the Job. In order to drill perfect holes in porcelain tile it is extremely important to use premium quality drill bits. Armeg have been producing innovative high quality drilling solutions for over 30 years and Armegs PTC (Porcelain Tile Cutter) range is at the forefront of tile drilling technology.
Simply start the drill in a vertical position and the sticky pad will ensure that the drill does not slip. Once you have finished drilling the tile simply peel off the sticky drive pad. Because the majority of small diameter holes will be cut into tiles already fixed to the wall it will be necessary to drill a fixing hole behind the tile. Replace the diamond core with the appropriately sized masonry drill bit and set the drill to hammer mode. Use a slow speed for drilling into hard materials to ensure that the tip doesnt overheat. Ensure that the drill bit is frequently withdrawn in order to stop a build up of dust.
It is not advisable to try and cool the drill bit by using an aspirator or drilling through a wet sponge these methods will not keep the drill bit cool enough and the drill bit will burn out. Set the electric drill to between 700 and 900 rpm. Make sure that the drill is in normal mode. Push the carbide drill bit gently into where you have marked the tile until you hear a cracking sound. Start drilling from a vertical position with sufficient pressure and dont stop until you hear a change in the tone of the drill. As soon as you hear the change in the tone begin to ease off.