Porcelain Tile / September 13, 2018 / Brousseau
It is not advisable to try and cool the drill bit by using an aspirator or drilling through a wet sponge these methods will not keep the drill bit cool enough and the drill bit will burn out. Set the electric drill to between 700 and 900 rpm. Make sure that the drill is in normal mode. Push the carbide drill bit gently into where you have marked the tile until you hear a cracking sound. Start drilling from a vertical position with sufficient pressure and dont stop until you hear a change in the tone of the drill. As soon as you hear the change in the tone begin to ease off.
Simply start the drill in a vertical position and the sticky pad will ensure that the drill does not slip. Once you have finished drilling the tile simply peel off the sticky drive pad. Because the majority of small diameter holes will be cut into tiles already fixed to the wall it will be necessary to drill a fixing hole behind the tile. Replace the diamond core with the appropriately sized masonry drill bit and set the drill to hammer mode. Use a slow speed for drilling into hard materials to ensure that the tip doesnt overheat. Ensure that the drill bit is frequently withdrawn in order to stop a build up of dust.
Porcelain tile and ceramic tile both start off the same being composed of more or less the same materials such as clay and quartz. After formation they are both fired to high temperatures. What spells out the difference between the ceramic white tile and porcelain tile is that the latter uses a more highly refined and purified clay making the porcelain tile denser than the other tile. This is an extremely important difference since being more dense means that porcelain tile absorbs far less moisture making it both durable and stain resistant.