Porcelain Tile / August 30, 2018 / Brousseau.
Because the majority of small diameter holes will be cut into tiles already fixed to the wall it will be necessary to drill a fixing hole behind the tile. Replace the carbide drill bit with the appropriately sized masonry drill bit and set the drill to hammer mode. Use a slow speed for drilling into hard materials to ensure that the tip doesnt overheat. Ensure that the drill bit is frequently withdrawn in order to stop a build up of dust.
Porcelain tile and ceramic tile both start off the same being composed of more or less the same materials such as clay and quartz. After formation they are both fired to high temperatures. What spells out the difference between the ceramic white tile and porcelain tile is that the latter uses a more highly refined and purified clay making the porcelain tile denser than the other tile. This is an extremely important difference since being more dense means that porcelain tile absorbs far less moisture making it both durable and stain resistant.
Drilling Small Diameter Holes (10mm or Smaller) with Carbide Bits. Firstly mark where the hole will be drilled on the tile using a marker. Attach a carbide drill bit to your drill. Ensure that there is a constant supply of cold water that is being directly aimed at the selected drill bit i.e. by using water cooling equipment. Note regarding water cooling. It is important to ensure that there is a constant supply of cold water in order to keep the drill bit cool and to help remove any debris that may have built up whilst drilling the tile.
The Takla Roma Travertino Collection has a marbleised appearance and can be found through many retailers for varying costs. These tiles have a water absorption rate of 0.04% and are first grade quality porcelain with a matte finish. There are a few different mosaics available in this line of tiles whose thickness is right at 3/8 inch. Armeg SDS Plus tile removing chisel also available in this range.