Porcelain Tile / June 16, 2018 / Brousseau.
Cheap porcelain tiles can be difficult to properly install. Cheap tiles may look nice on the surface but they may not be able to be cut cleanly with a tile saw and may chip on the edges. Also if the tiles are porous then it will be difficult to clean up the excess grout. Grout haze can become embedded in the tiles and make them look vastly different after they are installed compared to what they looked like before they were installed. Cheap tiles can have quality control issues. Many times people choose their sample tile and then order them.
Glazed porcelain tiles are ideal for the perfect flooring in your home. There are many differences between porcelain tiles and ceramic tiles for use on your floors or walls. Ceramic tiles are made from red or white clay and are fired then finished with a glaze that helps the pattern and colours to be sustained. These are normally easy to cut due to softer materials and have a PEI 0-3 rating. Porcelain tiles are made by dust pressed methods from porcelain clay that creates a fine grain and smooth face.
Identifying the Size of Hole to be Drilled. The first step is to correctly identify the size of hole to be drilled. This is very important as the diameter of the hole to be cut dictates the method that you will use to drill into the tile. The majority of holes that are 10mm and under in diameter will be drilled with the tile already fixed to the wall. Conversely the majority of holes over 10mm in diameter will be drilled into the tile before the tile has been fixed. When drilling holes that are 13mm or larger in diameter make sure that the tile to be drilled is placed in a tray that will collect the waste water that is produced.
Simply start the drill in a vertical position and the sticky pad will ensure that the drill does not slip. Once you have finished drilling the tile simply peel off the sticky drive pad. Because the majority of small diameter holes will be cut into tiles already fixed to the wall it will be necessary to drill a fixing hole behind the tile. Replace the diamond core with the appropriately sized masonry drill bit and set the drill to hammer mode. Use a slow speed for drilling into hard materials to ensure that the tip doesnt overheat. Ensure that the drill bit is frequently withdrawn in order to stop a build up of dust.