Porcelain Tile / August 21, 2018 / Brousseau
Simply start the drill in a vertical position and the sticky pad will ensure that the drill does not slip. Once you have finished drilling the tile simply peel off the sticky drive pad. Because the majority of small diameter holes will be cut into tiles already fixed to the wall it will be necessary to drill a fixing hole behind the tile. Replace the diamond core with the appropriately sized masonry drill bit and set the drill to hammer mode. Use a slow speed for drilling into hard materials to ensure that the tip doesnt overheat. Ensure that the drill bit is frequently withdrawn in order to stop a build up of dust.
It is not advisable to try and cool the drill bit by using an aspirator or drilling through a wet sponge these methods will not keep the drill bit cool enough and the drill bit will burn out. Set the electric drill to between 700 and 900 rpm. Make sure that the drill is in normal mode. Push the carbide drill bit gently into where you have marked the tile until you hear a cracking sound. Start drilling from a vertical position with sufficient pressure and dont stop until you hear a change in the tone of the drill. As soon as you hear the change in the tone begin to ease off.
To choose the right tiles that would best fit your needs it is important not to get lost with such terms as ceramic tiles non-porcelain or ceramic porcelain. All of these terms refer to a kind of ceramic ware however they differ in characteristics application and production method. Ceramic tiles are usually referred to as non-porcelain tiles and they are easier to cut and have higher water absorption as compared to porcelain. Unlike porcelain tiles ceramic tiles cannot absorb heavy impact or heavy foot traffic as they have a tendency to chip and abrade.