Porcelain Tile / August 29, 2018 / Brousseau
It is not advisable to try and cool the drill bit by using an aspirator or drilling through a wet sponge these methods will not keep the drill bit cool enough and the drill bit will burn out. Set the electric drill to between 700 and 900 rpm. Make sure that the drill is in normal mode. Push the carbide drill bit gently into where you have marked the tile until you hear a cracking sound. Start drilling from a vertical position with sufficient pressure and dont stop until you hear a change in the tone of the drill. As soon as you hear the change in the tone begin to ease off.
Attach the appropriate diamond core bit to the electric drill and ensure that there is a constant supply of cold water that is being directly aimed at the diamond core i.e. by using water cooling equipment. Note regarding water cooling. It is important to ensure that there is a constant supply of cold water directed at the drill bit in order to keep the diamond core cool and to help remove any debris that may have built up whilst drilling the tile. It is not advisable to try and cool the diamond drill bit by using a hand held aspirator or drilling through a wet sponge.
Some of the more common issues that cheap porcelain tiles can have include: Cheap porcelain tiles can actually be extremely porous and difficult to clean. They will absorb all types of dirt spills and contaminates. These types of porous tiles will start to show dirty spots especially in heavy use areas and in the center of the floor where people walk. Soon your floor will look ugly and these types of deeply embedded stains are extremely difficult to clean. Often times it can help to seal these porous tiles but this can be costly and time consuming especially for a product that you thought was dense and would be easy to clean and maintain.