Porcelain Tile / August 26, 2018 / Brousseau.
The Armeg PTC Diamond drill bit range boasts diamond core drill bits that are capable of cutting hundreds of holes in all grades of porcelain. They feature thin wall continuous diamond crowns for and fast and efficient cutting and an extended life. These diamond cores are not to be confused with short-life diamond grit alternatives. Not only do these diamond drill bits cut porcelain they also cut materials such as marble granite travertine slate quarry tiles ceramic tiles natural stone and limestone.
With porcelain being one of the most popular choices of tile material available and with the trend for porcelain tile set to continue tilers have had to adapt their working methods and tools to be able to cater for the demands of their clients. Until recently a large number of tile fixers have shied away from the installation and drilling of porcelain tiles due its perceived difficulty. However drilling holes in porcelain tile is not difficult! Using the correct methods and the best tools for the job it is possible to achieve perfect cuts in a matter of seconds.
Simply start the drill in a vertical position and the sticky pad will ensure that the drill does not slip. Once you have finished drilling the tile simply peel off the sticky drive pad. Because the majority of small diameter holes will be cut into tiles already fixed to the wall it will be necessary to drill a fixing hole behind the tile. Replace the diamond core with the appropriately sized masonry drill bit and set the drill to hammer mode. Use a slow speed for drilling into hard materials to ensure that the tip doesnt overheat. Ensure that the drill bit is frequently withdrawn in order to stop a build up of dust.
It is not advisable to try and cool the drill bit by using an aspirator or drilling through a wet sponge these methods will not keep the drill bit cool enough and the drill bit will burn out. Set the electric drill to between 700 and 900 rpm. Make sure that the drill is in normal mode. Push the carbide drill bit gently into where you have marked the tile until you hear a cracking sound. Start drilling from a vertical position with sufficient pressure and dont stop until you hear a change in the tone of the drill. As soon as you hear the change in the tone begin to ease off.