Porcelain Tile / September 13, 2018 / Brousseau
How to lean in... To lean in simply start the drill at an angle as soon as the drill bit has started to cut the tile slowly bring the drill into a vertical position. Ensure that sufficient pressure is being applied (tile dust should be evident in cooling water) and rotate slowly until you have cut the perfect hole. As you finish the hole you will notice that the tone of the drill will change. Using sticky drive pads. If you use a sticky drive pad it is unnecessary to use the leaning in method.
These tiles offer more water resistance and frost resistance than ceramic tiles. Glazed porcelain tiles offer a surface that is resistant to wear and tear and a harder surface that is great for high traffic areas such as the kitchen or tea room. Full porcelain floor tiles have a colour and pattern that follows through to the base of the tile so the patterns are never worn away like ceramic tiles. Glazed porcelain tiles are coated with liquid glass and then baked so that the protection is impervious to wear and tear as well as stains.
Drilling Small Diameter Holes (10mm or Smaller) with Carbide Bits. Firstly mark where the hole will be drilled on the tile using a marker. Attach a carbide drill bit to your drill. Ensure that there is a constant supply of cold water that is being directly aimed at the selected drill bit i.e. by using water cooling equipment. Note regarding water cooling. It is important to ensure that there is a constant supply of cold water in order to keep the drill bit cool and to help remove any debris that may have built up whilst drilling the tile.