Porcelain Tile / September 14, 2018 / Brousseau
The Armeg PTC Carbide drill bit range comprises of excellent porcelain tile drill bits that are capable of cutting 15-25 holes in grade 5 porcelain or 50+ in lesser grades of porcelain. These carbide drill bits boast non-slip start-up thanks to diamond-ground tip geometry. The Armeg PTC Soft Tile drill bit range is ideal for drilling softer tiles such as ceramics and travertine. They feature point-ground tips to help reduce slippage and wander. Armeg Tile Drilling Accessories for use with Armeg PTC drill bits include: water feed pump kit water feed adapters water feed clamp & drive/piloting guides to ensure non-slip start-up with small diameter diamond cores.
How to lean in... To lean in simply start the drill at an angle as soon as the drill bit has started to cut the tile slowly bring the drill into a vertical position. Ensure that sufficient pressure is being applied (tile dust should be evident in cooling water) and rotate slowly until you have cut the perfect hole. As you finish the hole you will notice that the tone of the drill will change. Using sticky drive pads. If you use a sticky drive pad it is unnecessary to use the leaning in method.
Application of tiles are rated according to the Porcelain Enamel Institute (PEI) rating system from PEI Class 1 up to PEI Class 5. If you are looking for the right tiles to be used for your walls or ceiling the PEI Class 1 is recommended because the tiles are not exposed to any impact. You can choose the PEI Classes 2 and 3 for your bathroom tiles and the PEI Classes 3 to 5 as kitchen and tabletops and as flooring in any part of your home or building according to the impact foot traffic or exposure of the area where you will install your porcelain tiles.