Porcelain Tile / September 14, 2018 / Brousseau.
The term porcelain was coined from the Italian word porcellana because of its translucent characteristic similar to the cowrie shell. Porcelain was first developed in China and was exported to Europe between the 17th and 18th century. Beautiful jars and other delicate ornaments were made from porcelain but the discovery of its base material from soft paste to hard past has made porcelain an important industrial commodity. Porcelain is resistant to high temperatures resistant to abrasions and is also non-porous which allows very minimal water absorption. Today porcelain is an important material for insulation and is popularly used for dental prosthesis and veneers. That is why porcelain tiles are excellent choices for residential and commercial finishing.
Simply start the drill in a vertical position and the sticky pad will ensure that the drill does not slip. Once you have finished drilling the tile simply peel off the sticky drive pad. Because the majority of small diameter holes will be cut into tiles already fixed to the wall it will be necessary to drill a fixing hole behind the tile. Replace the diamond core with the appropriately sized masonry drill bit and set the drill to hammer mode. Use a slow speed for drilling into hard materials to ensure that the tip doesnt overheat. Ensure that the drill bit is frequently withdrawn in order to stop a build up of dust.
Porcelain comes in many shapes sizes and beautiful designs. All of these characteristics seem to make porcelain the clear choice when it comes to quality durability and easy of cleaning and maintenance. In reality the truth can be vastly different. The specifications regarding porcelain tiles are never verified or tested so any manufacturer can claim that their tiles are porcelain. Tile manufacturers can claim that they are manufacturing porcelain tiles without having them tested. In many cases tiles labeled as porcelain do not have the characteristics that make them quality tiles.
It is not advisable to try and cool the drill bit by using an aspirator or drilling through a wet sponge these methods will not keep the drill bit cool enough and the drill bit will burn out. Set the electric drill to between 700 and 900 rpm. Make sure that the drill is in normal mode. Push the carbide drill bit gently into where you have marked the tile until you hear a cracking sound. Start drilling from a vertical position with sufficient pressure and dont stop until you hear a change in the tone of the drill. As soon as you hear the change in the tone begin to ease off.