Porcelain Tile / September 14, 2018 / Brousseau
Ensure that scrap tiles or another similar material is placed under the tile that is being drilled. This will help to halt the progress of the drill once it has finished drilling through the tile. Before drilling tile ensure that you are wearing the correct safety equipment including safety glasses or goggles. Ensure that you are using a residual current device (RCD) to help prevent electric shock. Drilling Small Diameter Holes (10mm or Smaller) with Diamond Cores. Mark the center of the hole to be drilled into the tile by using a marker or a sticky drive pad.
How to lean in... To lean in simply start the drill at an angle as soon as the drill bit has started to cut the tile slowly bring the drill into a vertical position. Ensure that sufficient pressure is being applied (tile dust should be evident in cooling water) and rotate slowly until you have cut the perfect hole. As you finish the hole you will notice that the tone of the drill will change. Using sticky drive pads. If you use a sticky drive pad it is unnecessary to use the leaning in method.
There was a time in the past when porcelain was synonymous with decorative pieces such as vases chinaware figurines and the like. The misconception that porcelain was fragile or delicate was common. However the many uses of porcelain have grown through time and it continues to be a valuable material in the dental profession for dental prosthesis and dental veneers. Today porcelain is a major industrial material used in insulation because porcelain is highly resistant to heat resistant to abrasion and is non-porous. That is why porcelain makes excellent floor tiles for both residential and commercial use.