Porcelain Tile / September 14, 2018 / Brousseau
Cheap porcelain tiles can be difficult to properly install. Cheap tiles may look nice on the surface but they may not be able to be cut cleanly with a tile saw and may chip on the edges. Also if the tiles are porous then it will be difficult to clean up the excess grout. Grout haze can become embedded in the tiles and make them look vastly different after they are installed compared to what they looked like before they were installed. Cheap tiles can have quality control issues. Many times people choose their sample tile and then order them.
The Takla Roma Travertino Collection has a marbleised appearance and can be found through many retailers for varying costs. These tiles have a water absorption rate of 0.04% and are first grade quality porcelain with a matte finish. There are a few different mosaics available in this line of tiles whose thickness is right at 3/8 inch. Armeg SDS Plus tile removing chisel also available in this range.
Now that the pilot hole has been cut it is possible to drill the main (large) hole. Attach the appropriate diamond core and ensure that there is a constant supply of cold water (see water cooling information in the previous sections of this article). Diamond cores that are larger than 13mm will require an adapter with pilot pin that locates into the pilot hole that has been cut previously to ensure the perfect hole will be made. Starting the drill vertically begin to drill in a circular motion with sufficient pressure until the tone of the drill changes.