Porcelain Tile / September 14, 2018 / Brousseau
How to lean in... To lean in simply start the drill at an angle as soon as the drill bit has started to cut the tile slowly bring the drill into a vertical position. Ensure that sufficient pressure is being applied (tile dust should be evident in cooling water) and rotate slowly until you have cut the perfect hole. As you finish the hole you will notice that the tone of the drill will change. Using sticky drive pads. If you use a sticky drive pad it is unnecessary to use the leaning in method.
Cheap porcelain tiles can be difficult to properly install. Cheap tiles may look nice on the surface but they may not be able to be cut cleanly with a tile saw and may chip on the edges. Also if the tiles are porous then it will be difficult to clean up the excess grout. Grout haze can become embedded in the tiles and make them look vastly different after they are installed compared to what they looked like before they were installed. Cheap tiles can have quality control issues. Many times people choose their sample tile and then order them.
Glazed porcelain tiles are ideal for the perfect flooring in your home. There are many differences between porcelain tiles and ceramic tiles for use on your floors or walls. Ceramic tiles are made from red or white clay and are fired then finished with a glaze that helps the pattern and colours to be sustained. These are normally easy to cut due to softer materials and have a PEI 0-3 rating. Porcelain tiles are made by dust pressed methods from porcelain clay that creates a fine grain and smooth face.