Porcelain Tile / September 14, 2018 / Brousseau
How to lean in... To lean in simply start the drill at an angle as soon as the drill bit has started to cut the tile slowly bring the drill into a vertical position. Ensure that sufficient pressure is being applied (tile dust should be evident in cooling water) and rotate slowly until you have cut the perfect hole. As you finish the hole you will notice that the tone of the drill will change. Using sticky drive pads. If you use a sticky drive pad it is unnecessary to use the leaning in method.
For the easiest to clean and maintain floors ceramic and porcelain tiles seem to make the most sense. In theory the specifications regarding porcelain tiles make them vastly superior to ceramic tile. The specifications state that porcelain tiles are harder and more scratch resistant than ceramic. Porcelain is supposed to be denser and less porous then ceramic. Many people like the idea that some porcelain tiles are through body where the entire porcelain tile is the exact same color and texture as the surface.
Drilling Small Diameter Holes (10mm or Smaller) with Carbide Bits. Firstly mark where the hole will be drilled on the tile using a marker. Attach a carbide drill bit to your drill. Ensure that there is a constant supply of cold water that is being directly aimed at the selected drill bit i.e. by using water cooling equipment. Note regarding water cooling. It is important to ensure that there is a constant supply of cold water in order to keep the drill bit cool and to help remove any debris that may have built up whilst drilling the tile.