Porcelain Tile / September 14, 2018 / Brousseau
With porcelain being one of the most popular choices of tile material available and with the trend for porcelain tile set to continue tilers have had to adapt their working methods and tools to be able to cater for the demands of their clients. Until recently a large number of tile fixers have shied away from the installation and drilling of porcelain tiles due its perceived difficulty. However drilling holes in porcelain tile is not difficult! Using the correct methods and the best tools for the job it is possible to achieve perfect cuts in a matter of seconds.
Porcelain tiles may be classified into natural glazed and polished tiles. The natural porcelain tile normally does not undergo any further finish after it is exposed to high temperature. This type of tile may be referred to as unglazed or through body tile where the colour goes all the way through. The glazed tile is coated with liquid glass that allows the manufacturer to put in a variety of designs and play around with colours. It comes out glossy and is one of the easiest to maintain. They are highly recommended as walls or accents in bathrooms and kitchen.
How to lean in... To lean in simply start the drill at an angle as soon as the drill bit has started to cut the tile slowly bring the drill into a vertical position. Ensure that sufficient pressure is being applied (tile dust should be evident in cooling water) and rotate slowly until you have cut the perfect hole. As you finish the hole you will notice that the tone of the drill will change. Using sticky drive pads. If you use a sticky drive pad it is unnecessary to use the leaning in method.