Porcelain Tile / September 14, 2018 / Brousseau
How to lean in... To lean in simply start the drill at an angle as soon as the drill bit has started to cut the tile slowly bring the drill into a vertical position. Ensure that sufficient pressure is being applied (tile dust should be evident in cooling water) and rotate slowly until you have cut the perfect hole. As you finish the hole you will notice that the tone of the drill will change. Using sticky drive pads. If you use a sticky drive pad it is unnecessary to use the leaning in method.
With porcelain being one of the most popular choices of tile material available and with the trend for porcelain tile set to continue tilers have had to adapt their working methods and tools to be able to cater for the demands of their clients. Until recently a large number of tile fixers have shied away from the installation and drilling of porcelain tiles due its perceived difficulty. However drilling holes in porcelain tile is not difficult! Using the correct methods and the best tools for the job it is possible to achieve perfect cuts in a matter of seconds.
Application of tiles are rated according to the Porcelain Enamel Institute (PEI) rating system from PEI Class 1 up to PEI Class 5. If you are looking for the right tiles to be used for your walls or ceiling the PEI Class 1 is recommended because the tiles are not exposed to any impact. You can choose the PEI Classes 2 and 3 for your bathroom tiles and the PEI Classes 3 to 5 as kitchen and tabletops and as flooring in any part of your home or building according to the impact foot traffic or exposure of the area where you will install your porcelain tiles.