Porcelain Tile / September 14, 2018 / Brousseau
Because the majority of small diameter holes will be cut into tiles already fixed to the wall it will be necessary to drill a fixing hole behind the tile. Replace the carbide drill bit with the appropriately sized masonry drill bit and set the drill to hammer mode. Use a slow speed for drilling into hard materials to ensure that the tip doesnt overheat. Ensure that the drill bit is frequently withdrawn in order to stop a build up of dust.
Ensure that scrap tiles or another similar material is placed under the tile that is being drilled. This will help to halt the progress of the drill once it has finished drilling through the tile. Before drilling tile ensure that you are wearing the correct safety equipment including safety glasses or goggles. Ensure that you are using a residual current device (RCD) to help prevent electric shock. Drilling Small Diameter Holes (10mm or Smaller) with Diamond Cores. Mark the center of the hole to be drilled into the tile by using a marker or a sticky drive pad.
The polished porcelain on the other hand goes through a more refined process and comes out looking almost like a granite finish or has a glossy effect without the glaze. In choosing the perfect ceramic porcelain tiles for your finishing you must know the colour combination or contrast in the areas where you will install the tiles and the kind of exposure the tiles may be subjected to. You may discuss these with your architect or interior designer or you may refer to our website and get in touch with us so we can assist you the best way we can.