Porcelain Tile / August 31, 2018 / Brousseau.
How to lean in... To lean in simply start the drill at an angle as soon as the drill bit has started to cut the tile slowly bring the drill into a vertical position. Ensure that sufficient pressure is being applied (tile dust should be evident in cooling water) and rotate slowly until you have cut the perfect hole. As you finish the hole you will notice that the tone of the drill will change. Using sticky drive pads. If you use a sticky drive pad it is unnecessary to use the leaning in method.
With porcelain being one of the most popular choices of tile material available and with the trend for porcelain tile set to continue tilers have had to adapt their working methods and tools to be able to cater for the demands of their clients. Until recently a large number of tile fixers have shied away from the installation and drilling of porcelain tiles due its perceived difficulty. However drilling holes in porcelain tile is not difficult! Using the correct methods and the best tools for the job it is possible to achieve perfect cuts in a matter of seconds.
To choose the right tiles that would best fit your needs it is important not to get lost with such terms as ceramic tiles non-porcelain or ceramic porcelain. All of these terms refer to a kind of ceramic ware however they differ in characteristics application and production method. Ceramic tiles are usually referred to as non-porcelain tiles and they are easier to cut and have higher water absorption as compared to porcelain. Unlike porcelain tiles ceramic tiles cannot absorb heavy impact or heavy foot traffic as they have a tendency to chip and abrade.
These methods will not keep the drill bits cool enough and will drastically shorten the life of the drill bit. Ensure that the drill is in normal mode and set the drill to between 1000 and 1500 rpm. If you have marked the tile with a marker it is best to drill into the tile using a method called leaning in. Leaning in ensures that the drill will not slip and wander off center as you begin to drill into the tile.