Porcelain Tile / August 31, 2018 / Brousseau
In choosing your tiles do not get confused with the terms non-porcelain and ceramic tiles because although technically porcelain is a kind of ceramic ware the term ceramic tile is usually referred to as non-porcelain. These tiles are hard and non-porous and absorb very minimal water as compared to ceramic tiles which are softer and have high water absorption. Porcelain tiles are highly durable because they can resist abrasions unlike ceramic tiles that are prone to chipping and scratches.
How to lean in... To lean in simply start the drill at an angle as soon as the drill bit has started to cut the tile slowly bring the drill into a vertical position. Ensure that sufficient pressure is being applied (tile dust should be evident in cooling water) and rotate slowly until you have cut the perfect hole. As you finish the hole you will notice that the tone of the drill will change. Using sticky drive pads. If you use a sticky drive pad it is unnecessary to use the leaning in method.
With porcelain being one of the most popular choices of tile material available and with the trend for porcelain tile set to continue tilers have had to adapt their working methods and tools to be able to cater for the demands of their clients. Until recently a large number of tile fixers have shied away from the installation and drilling of porcelain tiles due its perceived difficulty. However drilling holes in porcelain tile is not difficult! Using the correct methods and the best tools for the job it is possible to achieve perfect cuts in a matter of seconds.