Porcelain Tile / August 31, 2018 / Brousseau
It is not advisable to try and cool the drill bit by using an aspirator or drilling through a wet sponge these methods will not keep the drill bit cool enough and the drill bit will burn out. Set the electric drill to between 700 and 900 rpm. Make sure that the drill is in normal mode. Push the carbide drill bit gently into where you have marked the tile until you hear a cracking sound. Start drilling from a vertical position with sufficient pressure and dont stop until you hear a change in the tone of the drill. As soon as you hear the change in the tone begin to ease off.
Are you building your new home? Or are have you grown tired of your marble flooring or the chip on your wall paper or the drab of your wooden panels? It is time to switch or consider porcelain tiles. These tiles not only brighten up your home they are durable and almost maintenance free. You can choose from the wide selection of perfect porcelain tile designs for your home.
Drilling Small Diameter Holes (10mm or Smaller) with Carbide Bits. Firstly mark where the hole will be drilled on the tile using a marker. Attach a carbide drill bit to your drill. Ensure that there is a constant supply of cold water that is being directly aimed at the selected drill bit i.e. by using water cooling equipment. Note regarding water cooling. It is important to ensure that there is a constant supply of cold water in order to keep the drill bit cool and to help remove any debris that may have built up whilst drilling the tile.