Porcelain Tile / September 14, 2018 / Brousseau.
These methods will not keep the drill bits cool enough and will drastically shorten the life of the drill bit. Ensure that the drill is in normal mode and set the drill to between 1000 and 1500 rpm. If you have marked the tile with a marker it is best to drill into the tile using a method called leaning in. Leaning in ensures that the drill will not slip and wander off center as you begin to drill into the tile.
Cheap porcelain tiles can be difficult to properly install. Cheap tiles may look nice on the surface but they may not be able to be cut cleanly with a tile saw and may chip on the edges. Also if the tiles are porous then it will be difficult to clean up the excess grout. Grout haze can become embedded in the tiles and make them look vastly different after they are installed compared to what they looked like before they were installed. Cheap tiles can have quality control issues. Many times people choose their sample tile and then order them.
This ruggedness is why tiles made of porcelain are the ones most often found in floor applications for outdoor living spaces its because they are far better at handling harsh conditions. Tiles made of porcelain are practically a must for outdoor patios in cold weather climates because unlike normal ceramic tiles they are far less likely to crack. Not only can they endure the elements better but the unique absorption rate and density of means that moisture and dirt have a hard time getting through the surface. That means that the tiles look cleaner and retain their color for a longer period of time.
Drilling Large Diameter Holes (13mm or Larger). In order to cut holes that are 13mm or larger in diameter it is necessary to first drill a pilot hole. The pilot hole will act as a locater for a large diamond core and will help you to drill a perfect hole in porcelain tile. Attach an 8mm carbide drill bit or 8mm diamond bit to your drill. Follow the instructions given above for either Drilling Small Diameter Holes (10mm or Smaller) with Diamond Cores or Drilling Small Diameter Holes (10mm or Smaller) with Carbide Bits depending on whether you are using diamond cores or carbide drill bits. Leave out the final step in either case as you wont be drilling a fixing hole behind the tile.