Porcelain Tile / September 3, 2018 / Brousseau.
Simply start the drill in a vertical position and the sticky pad will ensure that the drill does not slip. Once you have finished drilling the tile simply peel off the sticky drive pad. Because the majority of small diameter holes will be cut into tiles already fixed to the wall it will be necessary to drill a fixing hole behind the tile. Replace the diamond core with the appropriately sized masonry drill bit and set the drill to hammer mode. Use a slow speed for drilling into hard materials to ensure that the tip doesnt overheat. Ensure that the drill bit is frequently withdrawn in order to stop a build up of dust.
The hardness of porcelain tiles is an advantage for more reasons than appearance. This quality makes these tiles far more scratch resistant than ceramic tiles. When tiles get scratched up you have to go to a lot of expense and trouble to get them polished out and sometimes even that isnt possible. Porcelain tiles are also more resistant to chipping. This hardy nature also makes them less slippery than ceramic tiles which makes them a better choice for safety reasons as well.
As mentioned most people find the look of clean white tile to be universally appealing. It adds a brightness to a living space giving it the appearance of being more open and welcoming. This is where porcelain tiles have the advantage of the more common ceramic white tiles. Porcelain is sleek clean and beautiful and the difference in appearance is noticeable. In fact they dont just look cleaner; due to their density and hardness porcelain materials (tiles) are more impervious to dirt and are much easier to clean.
Drilling Large Diameter Holes (13mm or Larger). In order to cut holes that are 13mm or larger in diameter it is necessary to first drill a pilot hole. The pilot hole will act as a locater for a large diamond core and will help you to drill a perfect hole in porcelain tile. Attach an 8mm carbide drill bit or 8mm diamond bit to your drill. Follow the instructions given above for either Drilling Small Diameter Holes (10mm or Smaller) with Diamond Cores or Drilling Small Diameter Holes (10mm or Smaller) with Carbide Bits depending on whether you are using diamond cores or carbide drill bits. Leave out the final step in either case as you wont be drilling a fixing hole behind the tile.