Porcelain Tile / September 13, 2018 / Brousseau
To choose the right tiles that would best fit your needs it is important not to get lost with such terms as ceramic tiles non-porcelain or ceramic porcelain. All of these terms refer to a kind of ceramic ware however they differ in characteristics application and production method. Ceramic tiles are usually referred to as non-porcelain tiles and they are easier to cut and have higher water absorption as compared to porcelain. Unlike porcelain tiles ceramic tiles cannot absorb heavy impact or heavy foot traffic as they have a tendency to chip and abrade.
Simply start the drill in a vertical position and the sticky pad will ensure that the drill does not slip. Once you have finished drilling the tile simply peel off the sticky drive pad. Because the majority of small diameter holes will be cut into tiles already fixed to the wall it will be necessary to drill a fixing hole behind the tile. Replace the diamond core with the appropriately sized masonry drill bit and set the drill to hammer mode. Use a slow speed for drilling into hard materials to ensure that the tip doesnt overheat. Ensure that the drill bit is frequently withdrawn in order to stop a build up of dust.
Drilling Small Diameter Holes (10mm or Smaller) with Carbide Bits. Firstly mark where the hole will be drilled on the tile using a marker. Attach a carbide drill bit to your drill. Ensure that there is a constant supply of cold water that is being directly aimed at the selected drill bit i.e. by using water cooling equipment. Note regarding water cooling. It is important to ensure that there is a constant supply of cold water in order to keep the drill bit cool and to help remove any debris that may have built up whilst drilling the tile.