Porcelain Tile / September 12, 2018 / Brousseau.
Glazed porcelain can be found through many online retailers for varying costs. Here are a few different types of glazed porcelain that can be used in any area of the home. The Wood Grain Collection made by Takla offers your floors the hard wood appearance with the protection of glazed porcelain. These tiles have a water absorption rate of less than 0.05% and are first grade quality porcelain. The thickness of the average tile of this type is 3/8 inch and the finish is matter and slightly embossed to have the appearance of wood grain. The PEI rating for these tiles is 4 and they are considered a green building material.
When it comes to deciding which tile to use in your home most people waver between choosing porcelain tile or a ceramic white tile. Certainly both have great qualities bringing beauty and charm into the space you are living in. Good quality tile adds an elegant tastefulness to a room as well as providing flooring that can stand up to more use than wood or carpet. This is why its so important to make sure youre choosing the right kind of tile. Everyone loves the clean bright look of white tile so its little wonder that people wonder if they should use ceramic or porcelain tile. A lot of DIY tile installers ask the difference between the two and the answer is surprising. Despite a superficial similarity differences abound between the two types of tile.
Drilling Large Diameter Holes (13mm or Larger). In order to cut holes that are 13mm or larger in diameter it is necessary to first drill a pilot hole. The pilot hole will act as a locater for a large diamond core and will help you to drill a perfect hole in porcelain tile. Attach an 8mm carbide drill bit or 8mm diamond bit to your drill. Follow the instructions given above for either Drilling Small Diameter Holes (10mm or Smaller) with Diamond Cores or Drilling Small Diameter Holes (10mm or Smaller) with Carbide Bits depending on whether you are using diamond cores or carbide drill bits. Leave out the final step in either case as you wont be drilling a fixing hole behind the tile.
It is not advisable to try and cool the drill bit by using an aspirator or drilling through a wet sponge these methods will not keep the drill bit cool enough and the drill bit will burn out. Set the electric drill to between 700 and 900 rpm. Make sure that the drill is in normal mode. Push the carbide drill bit gently into where you have marked the tile until you hear a cracking sound. Start drilling from a vertical position with sufficient pressure and dont stop until you hear a change in the tone of the drill. As soon as you hear the change in the tone begin to ease off.