Porcelain Tile / September 14, 2018 / Brousseau
Simply start the drill in a vertical position and the sticky pad will ensure that the drill does not slip. Once you have finished drilling the tile simply peel off the sticky drive pad. Because the majority of small diameter holes will be cut into tiles already fixed to the wall it will be necessary to drill a fixing hole behind the tile. Replace the diamond core with the appropriately sized masonry drill bit and set the drill to hammer mode. Use a slow speed for drilling into hard materials to ensure that the tip doesnt overheat. Ensure that the drill bit is frequently withdrawn in order to stop a build up of dust.
Drilling Large Diameter Holes (13mm or Larger). In order to cut holes that are 13mm or larger in diameter it is necessary to first drill a pilot hole. The pilot hole will act as a locater for a large diamond core and will help you to drill a perfect hole in porcelain tile. Attach an 8mm carbide drill bit or 8mm diamond bit to your drill. Follow the instructions given above for either Drilling Small Diameter Holes (10mm or Smaller) with Diamond Cores or Drilling Small Diameter Holes (10mm or Smaller) with Carbide Bits depending on whether you are using diamond cores or carbide drill bits. Leave out the final step in either case as you wont be drilling a fixing hole behind the tile.
Porcelain tile and ceramic tile both start off the same being composed of more or less the same materials such as clay and quartz. After formation they are both fired to high temperatures. What spells out the difference between the ceramic white tile and porcelain tile is that the latter uses a more highly refined and purified clay making the porcelain tile denser than the other tile. This is an extremely important difference since being more dense means that porcelain tile absorbs far less moisture making it both durable and stain resistant.